Specifications

ACI/Frangkiser Hutchens Architects 4-07058

Liberty "North" Second High School

Liberty Public School District #53

Building Construction Bid Set

FOOD SERVICE EQUIPMENT 11400-19

allowed. Sink bowl bottom creased/sloped to drain to

provide complete drainage of sink. At drain valve

location, sink bottom ferruled downward to allow installed

drain valve grate to set flush to or below plane of sink

bottom. 14 ga. S/S ―L‖ bracket stud bolted to bottom of sink

bowl to support drain twist action handle. Punch splash

top, deck or splash face for trim, as specified. Faucets

centered over sink compartment or centered over partitions

if multi-compartment sink. Provide sink underside with

smooth 1/16" thick coat of sound deadening mastic, painted

aluminum. Integral sinks shall be continuously welded

into the metal top, ground smooth and polished.

Backsplash, Metal Top and base as specified for the

specific item.

8. Dish Table Tops:

a. Materials;

1) Dish Table Top / backsplash / back splash ends / rims

/ sinks shall be Stainless Steel.

2) Dish Table Top under bracing; shall be Stainless

Steel.

b. Dish table top shall be 14 ga. All exposed edges shall be

turned straight up 3" high with Raised Box Edge as detailed;

terminate at back splash and weld thereto. Box Edge shall

have square corners. Turn down into dish machine in a water

tight manner per the dish machine manufacturers

recommendations. Under brace dish table top with 1" x 4"

x 1" channel or 1-1/2" x 1-1/2" angles both lengthwise and

widthwise 18" O.C. Stud bolt under bracing to top. Top

shall be sound deadened.

c. When top is adjacent to walls, it shall be turned straight

up 8" and back 2" on 45

angle, unless otherwise specified.

Turn splash top down 90

for ½" on the back unless otherwise

specified. Cove vertical and horizontal corners on ½" R.

No solder or caulked fillets allowed. Fully weld

Stainless Steel fillers into exposed open splash ends.

Seal splash top, back edges to walls. Provide holes in back

splash and top for fittings and fixtures as required.