Specifications

ACI/Frangkiser Hutchens Architects 4-07058

Liberty "North" Second High School

Liberty Public School District #53

Building Construction Bid Set

FOOD SERVICE EQUIPMENT 11400-18

non-movable counter top equipment without legs shall be

sealed to the countertop. Any joints or portions there of

exceeding 3/8" shall be covered for its entire length by

a Stainless Steel closure of a design approved by the Food

Facilities Consultant.

b. Between abutting work surface / serving line Metal Tops,

provide sealant on adbutting surfaces, at installation,

with minimum of exposed sealant on finished / exposed

surfaces. Sloppy and excessive sealant joints will not be

accepted.

7. Metal Tops:

a. Material;

1) Top / backsplash / back splash ends / sinks; shall be

Stainless Steel.

2) Top under bracing; shall be Stainless Steel or

Ferritic Stainless Steel.

b. Metal top shall be 14 ga. Exposed edges of tables shall

have standard Box Edge as detailed; angle table top up at

45 x 3/4"H. with 1" flat top, turn down 1-1/2", with ½"

toe-in on 30

angle. At abacking tables, provide 1-1/2"

turn-up or 2" turn-up with 2" turn back and 1" turn down

to form Curb Backsplash as specified and detailed.

Adjacent to walls or other non-mobile equipment, provide

splashes of height and width specified, 14 gauge and

integral with top. Slope splash top back 2" on an upward

angle to adjacent walls, where shown. At walls or

taller equipment, turn splash top down 90

for ½" on the

back unless otherwise specified. All vertical and

horizontal corners at splashes or turn-ups shall be coved

on 1/4" R. No solder fillets allowed. Fully weld

Stainless Steel fillers into exposed open splash ends.

Under brace the top with 1" x 4" x 1" channel or 1-1/2" x

1-1/2" angles both lengthwise and widthwise 18" O.C. Stud

bolt under bracing to top. Seal splash top, back edges to

walls and adjacent non-mobile equipment. Sound deaden the

top.

c. When sinks are specified integral to the Metal Top,

construct sink with all bowl vertical and horizontal

corners coved on 1" R. No solder or caulked fillets