Specifications

ADJUSTMENTS – ILL. B
5
The Dispense Valves are factory adjusted for a maximum Flow Rate of
1
to
1.3
oz./sec.
[Approximate settings: 0.85 to 1 oz./sec for SOUP; 1.3 oz/sec. for COFFEE and CAPPUCCINO]
Exceeding this Flow Rate will cause the Mixing Chamber to overflow.
Note: To access the Water Dispense Valves, open door and remove Hoppers.
TO ADJUST WATER FLOW RATE:
1. Open door and remove hoppers. Locate Dispense Valve behind hoppers, mounted on tank.
2. Locate adjustment screw on Dispense Valve.
3. Using Alien Key or flat screwdriver rotate, 1/4 turn at a time,
CLOCKWISE to decrease water flow, or
COUNTERCLOCKWISE to increase water flow.
4. Check water flow output, after each 1/4 turn.
CD130 NYLON AUGER [22.5mm0 X 17mmPT]
W/0-RINGCD139
CD101 WIRE AUGER [22.5mm0 X 17mmPT]
CAPPUCCINO/FAST FLOW & SOUP
CD149 WIRE AUGER {22.5mm0 X 24.8mmPT]
HOT CHOCOLATE & THICK SOUP
CD74A WIRE AUGER {17mm0 X 12mmPT]
DRY COFFEE/FAST FLOW
CD153 WIRE AUGER
[17mm0
X 9.15mmPT]
DRY COFFEE & INSTANT ESPRESSO
A. When using
NYLON AUGERS
:
Adjust Water Flow Rate so that the
water level reaches almost at the top
in the Mixing Chamber, as shown.
B. When using WIRE AUGERS:
Adjust Water Flow Rate so that the
water level reaches half way up in
the Mixing Chamber, as shown.