Specifications

MAINTENANCE INSTRUCTIONS (See Illustration A):

LIT DISPLAY LAMP AND STARTER REPLACEMENT

1. To replace the lamp, first remove the upper inside door panel. Turn the lamp and pull it out of the lamp holder,

then place the new lamp into the lamp holder and turn it until it snaps into position.

2. To replace the starter, remove the upper inside door panel, turn the starter slightly counter-clockwise and take it

out of the starter base. To install the new starter, snap the starter into the starter base and turn it slightly clockwise

into position.

RECOMMENDED DAILY CLEANING

1. Turn the power switch to OFF.

2. Remove the drip tray with grill and empty the contents. Wash with mild dishwasher detergent and dry.

Cleaning the Hopper

1. Open the cabinet door and raise the top cabinet lid.

2. Take the hopper out of the cabinet.

3. Pull off the elbow chute and remove the hopper cover.

4. Rinse each item thoroughly.

5. Dry all items and reassemble.

Filling the Hopper

1. Open the cabinet door, raise the top cabinet lid.

2. Fill the hopper with the correct product. Note: The Hopper can also be removed for filling.

3. Reposition hopper in the hopper compartment, making sure the hopper is properly seated.

Flushing the Whipper Chamber

1. Turn the POWER switch and RINSE switch to ON.

2. Place a container under dispense nozzle and push the Dispense Button.

Note: On manual dispense machines, push and hold the dispense buttons for 10 seconds.

3. Turn the Rinse switch back to OFF.

Removing and Cleaning the Cappuccino Whipper Chamber

1. Remove the dispense cap by pulling it forward and at the same time twisting it clockwise.

2. Pull the mixing bowl out of the mixing bowl socket.

3. Twist the whipping chamber clockwise and pull it off the mounting plate.

4. Pull the Whipper blade off the motor shaft. Notice the flat keyway on the shaft and the

matching keyway inside the Whipper blade shaft. It is important that these two keyways are lined up when re-assembling the

components.

5. Twist the mounting plate clockwise and pull it off the motor shaft.

6. Slip off the o-ring from the Whipper chamber mounting plate and clean o-ring and o-ring seat.

Removing and Cleaning Mixing Chambers

1. Remove the dispense cap.

2. Pull the mixing bowl out of the mixing bowl socket.

3. Take out the extension tubes.

4. Rinse thoroughly.