Specifications

INSTALLATION REQUIREMENTS:
This equipment is to be installed to comply with the applicable federal, state, or local plumbing codes having jurisdiction.
In addition:
1. A quick disconnect water connection or enough extra coiled tubing (at least the depth of the unit) so that the machine can be moved for cleaning
underneath.
2. An approved back flow prevention device, such as a double check valve to be installed between the machine and the water supply.
INSTALLATION & PRIMING:
1. Flush inlet water line thoroughly before connecting. If pipe sealant is necessary, Teflon tape is commended.
2. Connect water line to the 1/4" flare fitting located at rear of the unit. A shutoff valve in the water supply line is advisable.
3. Turn on water. Check water line and fittings for leaks.
4. Put HEATER Switch OFF.
5. Plug the power cord into a grounded 120 volt, 60 Hz 15 Amp outlet, Single use. It will take 2 to 4 minutes to fill the tank.
6. Put RINSE Switch ON.
7. Press Dispense Button until water flows out of the dispense nozzle ( 6 to 7 min.). Tank will fill up.
8. PUT RINSE Switch OFF.
9. Put HEATER Switch ON and allow 10 to 15 minutes for water to reach brew temperature.
10. Fill hopper with DRY* powdered product, while waiting for water in tank to heat up. See filling instructions.
11. Push Dispensing Button and check the operation of the hopper. A grinding noise will be heard if not properly engaged.
12. Push Dispensing Button and check drink taste. If adjustments are needed, see "Water Flow Adjustments".
NORMAL DAILY DISPENSER OPERATION
FILLING
1. Open Front Door and lift Top Cover.
2. Fill hopper to desired level with DRY powdered mix.
*Moist product will clog hopper and the unit will not operate properly.
*Never REFRIGERATE powdered product.
Do not overfill or pack product down when filling.
3. Close Top Cover and Door.
DISPENSING
1. Place cup under mixing chamber spout.
2. a) For Manual Units (without Timer): Press and hold
push button until cup is approximately 2/3 full.
b) For Automatic Units (with Timer):
Press and release push button. Cup will fill to size set on Timer.
3. Remove cup when flow from mixing chamber has stopped completely.
WATER FLOW and DRINK STRENGTH ADJUSTMENTS
The unit is factory adjusted to dispense as follows:
Water Flow Rate : 1.2 oz./sec.
Powder/Product Flow Rate: 4 oz./sec.
Corresponding Gram Throw Rate: 4 gr. product per 1.2 oz. of water.
To increase or decrease Drink Strength, proceed as follows:
1. Remove right hand side Panel of unit. (looking from the front).
2. Locate Flow Adjustment Key inside unit mounted above water valve.
3. Engage Flow Adjustment Key into Flow Controller and rotate counterclockwise (CCW) to
decrease and clockwise (CW) to increase drink strength. When making strength
adjustments, do not turn
Adjustment Key more than 1/8" turn at a time without checking drink strength.
4. Return Adjustment Key back into keyholder. If after maximum adjustment.
3