User Guide

3. Open the control box and disconnect the two pump wires from the

quick disconnect terminals.

4. Loosen union fittings on pump and remove pump from urn.

5. Replace pump and follow priming instruction.

NOTE: Pump and motor assembly is factory lubricated for the life of the

pump.

• TIMER SOLID-STATE

Depress BREW button, hold for approximately 10 seconds, and then

release. If water flows from spray head when button is depressed and

stops flowing after button is released, then timer is faulty and should be

replaced. No water from spray head when button is depressed, indicates

BREW button is fault and must be replaced.

• AGITATOR

OPERATION: The agitator pump circuit is programmed to operate when

the BREW button is pushed. Upon completion of the pump cycle, the

agitator pump will pump air through the manifold into the coffee gauge

glasses and into the coffee liner. The completed cycle will take

approximately 20 second. The agitator may be operated independently

of the brewing cycle, if the agitator button is depressed.

MAITENANCE: The air pump is capable of delivering enough air for

proper blending. However if enough agitation is not present, check

flexible tubing on top of gauge glasses and fittings, for possible air leaks.

If air pump does not operate on completion of brewing cycle or when

agitation button is depressed, replace air pump or solid state agitator

timer (black box).

• BURNER MAITENANCE

The two main burners can be removed by first removing the base cover

panel and unfastening the burner ends. The main burners should be

cleaned both inside the venturi portion and on the outside using a soft

bristle brush. The main burners must be into the same position before

removal. Once a year, a qualified service agency should be contacted to

inspect the appliance for safe and proper operation.

PILOT ADJUSTMENT CAP

• SAFETY PILOT:

Remove pilot adjustment cap on

the gas valve and turn adjustment

screw to provide properly sized

flame (3/4 inch long).

Replace the cap.