Specifications

Z:\DRAWINGS\ND000\ND96A-A-LTB-MAN.dwg, 03/21/2002 04:35:12 PM, 1:8.07091
SIDE VIEW
SIPHONINING
NOZZLE
FUNNEL
FRONT VIEW
LABEL
BACK VIEW
ICED TEA
DISPENSER
10 gal.
LTB-1010
[8 OZ. TEA]
CAUTION: BEFORE PLUGGING POWER CORD INTO GROUNDED OUTLET [15A, 120V 0r 240V] MAKE SURE HEATER SWITCH IS OFF [on
back panel or inside top cabin].
I. PRIMING - FIRST TIME START UP CONNECTED TO DIRECT WATERLINE
1. CONNECT A 1/4 COPPER WATER LINE TO THE 1/4 FLARE WATER INLET FITTING ON THE VALVE.
2. PLUG POWER CORD INTO OUTLET [120V, 15A, GROUNDED, DEDICATED].
3. PRESS POWER SWITCH ON. Tank will start filling.
4. WAIT APPROXIMATELY 4 MIN. FOR TANK TO FILL UP, THEN TURN HEATER SWITCH ON [ Toggle UP - see lower back panel]
II. NORMAL EVERYDAY BREWING OPERATION:
For LTB-1010:
1. PLACE TEA BAGS [2] 4 oz. each, 8 oz. total, DIRECTLY ONTO FUNNEL PLATFORM.
2. Place Iced Tea Dispenser under funnel.
3. Turn power on. Allow approx. 15 minutes for water in tank to reach brewing temperature 197°F.
4. When "BREW" [green] light comes ON, press Brew Button [toggle down].
BREW/CAUTION LIGHT flashes during brewing cycle. DO NOT REMOVE FUNNEL WHILE LIGHT IS FLASHING.
BREW
CAUTION
LIGHT
TUBE
COLD WATER
6
HEATER
SWITCH
OR
INSIDE TOP
HOUSING
POWER
CORD
DUAL
WATER
INLET/
SOLENOID
VALVE
ICED TEA
BREW SW.
POWER
SWITCH
FAST START UP PROCEDURE FOR LTB -1010 & LTB-1010 TWIN