Specifications

Z:\DRAWINGS\ND000\ND96A-A-LTB-MAN.dwg, 03/21/2002 04:34:58 PM, 1:8.01226
SIDE VIEW FRONT VIEW
BACK VIEW
pump
water line
CAUTION: BEFORE PLUGGING POWER CORD INTO GROUNDED OUTLET [15A, 120V 0r 240V] MAKE SURE HEATER SWITCH IS OFF
[inside top cabin].
I PRIMING - FIRST TIME START UP USING PUMP
1. SET WATER SELECTION SWITCH [see lower back panel] TO "PUMP" [TOGGLE UP]
2. PLACE HOSE FROM PUMP [on back panel] INTO A 6 GAL. FULL WATER BOTTLE.
3. PLUG POWER CORD INTO OUTLET [120V, 15A, GROUNDED, DEDICATED].
4. PRESS POWER SWITCH ON. Pump priming button [red], located on lower front panel, will light up, indicating pump needs to be primed.
5. PUSH and HOLD PRIMING BUTTON UNTIL LIGHT GOES OFF, THEN RELEASE BUTTON. Pump begins to draw water from water bottle.
Pump will continue to draw water from the bottle on it's own, until the tank inside the machine is full.
Pump will take approximately 4 minutes to fill Tank.
6. TURN HEATER SWITCH ON [on lower back panel] .
Allow approx. 20 minutes for water inside tank to reach proper brewing temperature of 197°F.
II. NORMAL EVERYDAY BREWING OPERATION:
1. Insert Paper Filter with hole over stem and place Tea IN PAPER FILTER - OPTIONAL
or PLACE TEA [FOR LTB-303 [(1) 3 oz. bag or 2.5 - 3 oz. loose tea] or
[FOR LTB-505 [(1) 4 oz. bag or 3.5 - 4 oz. loose tea] DIRECTLY IN FUNNEL INSERT.
2. Place iced tea dispenser or airpot or satellite under funnel.
3. Turn power on. Allow approx. 20 minutes for water in tank to reach brewing temperature 195°F.
4. When "Ready" [green] light [front panel] comes ON, press Brew Button [HOT TEA or ICED TEA].
5. IF IN BETWEEN BREW CYCLES, THE PRIMING BUTTON LIGHTS UP, PRESS BREW SWITCH,
TO CONTINUE WITH NORMAL OPERATION.
III. AFTER DEMONSTRATION- PACK UP MACHINE:
1. SHUT OFF ALL SWITCHES
2. UNPLUG POWER CORD
3. DRAIN TANK INTO WATER BOTTLE [Drain Hose located in back]
CAUTION: WATER IN TANK IS HOT, 197°F.
ICED TEA
BREW SW.
HOT TEA
BREW SW.
READY LT.
HEATER LT.
POWER
SWITCH
LABEL
FUNNEL
BREW BASKET
SIPHONING TUBE
WATER INLET
VALVE-HAND
TIGHTEN
POWER CORD
LEGS
PUMP PRIMING
BUTTON
DRAIN
HOSE
WATER
SELECTION
BUTTON
PUMP HOSE TO
WATER BOTTLE
EMPTY 3 OZ. OF TEA INTO PAPER FILTER.
FILTER WITH HOLE [412 LIP] OVER STEM and
BEFORE BREWING, SLIP LIPTON PAPER FILTER
FILTER IS OPTIONAL
USED WHERE RINSING
FUNNEL IS LIMITED
5
FAST START UP INSTRUCTIONS FOR LTB PORTABLE (Lipton Portable Tea Brewer with Pump)
LTB-303 [2.5 - 3 OZ. TEA]
LTB-505 [3.5 - 4 OZ. TEA]