Datasheet

I-300

TIMER PROGRAMMING.

IMPORTANT. The timer as supplied factory is not recorded in any kind of timer, or time to work, you must schedule it

before first use.

Failure to act as a type 1 program, time 1 second.

STEPS TO SET THE TIMER

Disconnect the power

Select TIMER dips in the desired pattern

Select from the TIMER SCALE Dips desired time interval

Select the desired time adjustable potentiometer Once these 3 steps connect the power and the timer is programmed and

and ready to work.

Note. If you chose a starting model for voltage at power ripped

OPERATION

The timer is programmed and ready to go turn the power.

To start the timer press START button.

To stop / reset at any time tempización press STOP button

IMPORTANT. During the working time both DIPS programming time as the potentiometer are ignored by the timer, so you

can no longer function reschedule any work until the time runs out

RESCHEDULE. Disconnect the power and perform the same steps as indicated in the previous section PROGRAM TIMER

OUTPUT CONNECTION. LOAD. The output is controlled by a relay device that supports any type of load does not

exceed 3 A. The relay has three output terminals. The rest normally open (NO), the normally closed at rest (NC), and the

common operation of this mechanism is identical to a switch, whose two terminals NA and the common To perform the

inverse function must be used NC and Common terminals The figure shows the typical connection for a device with operation

to 12 V. DC. and another operating at 230 V. AC

12V DC

ABOUT THE OUTPUT. During operation of the circuit, and according to its load, may cause a fluctuation or an incorrect

operation of the output. If this occurs, install a spark between the two circuit relay contacts used in the connection, as shown

in the drawing

NOTE: To connect loads to 12 V. DC resistance and to eliminate single capacitor