Instructions

21
15. Installation and Configuration of the Outputs
a) „INCALL“ Output
The „INCALL“ output switches on for a defined time when the GSM module is called. Because the GSM module does not pick up, this is free of
charge!
Just call the GSM module and let it ring a few times. Then the „INCALL“ output switches on for the time set in the control software and then off
again automatically.
This is ideal, e.g., for a garage door opener or front door light. The activation time can be set in 12 stages from 0.2 seconds to 4 hours.
Proceed as follows to use the „INCALL“ output:
• Enter the phone number of the phone with which you want to call in the top line of „Phone“ in
„General Settings“.
• The phone number must be entered in international format.
Wrong: 01701234567
Correct: [phone]
• Click the checkbox „Used“ in „1 Incall Output“ so that the checkmark appears. The „INCALL“
output can now be configured.
• Click the switching duration „10 sec“ in „1 Incall output“.
• For a selection of phone numbers, choose one of the following options:
„Everyone can call“: The „INCALL“ output switches the connected relay for any call received.
„or called by all“: In this configuration, the GSM module can be controlled by any phone number
stored in the control software in „Phone“.
„or from“ (recommended for initial commissioning): The GSM module can only be controlled by
phone numbers selected by clicking them.
The boxes in the first, left column correspond to phone numbers 1 to 4 from top down; those in the second, medium column, correspond to
phone numbers 5 to 8 and those in the right column to phone numbers 9 to 12 as they were stored in the chapter „Determination of Phone
Numbers“.
• Finally, send the change to the GSM module again in „Communication“ (click button „Send“). The message „All data has been transferred!“
must appear.
• Now call the phone number of the SIM card inserted in the GSM module with your mobile phone. Let the phone ring a few times.
• The relay for the „INCALL“ output (figure 1, item 8) now has to activate and a red indicator LED has to show this.
• The relay must deactivate again after approx. 10 seconds, and the control LED goes out.
If the „INCALL“ output function was correct, this function can be freely used from now on. To control a function, connect a device to the
„INCALL“ relay contacts. For this, observe the maximum permissible voltages and currents in the technical data and the diagram note for
connection of a consumer by relay at the end of the operating instructions.
Attention!
If the control software is configured to „Everybody can call“, this output will activate at every call. This applies irrespective of whether
the phone number is included in the phone list or not.
Everyone who knows the phone number of the SIM card in the GSM module or calls it by accident (e.g. because he dials the wrong
number) will be able to control the GSM module! The module activates even if no phone number is transmitted. Therefore, we
recommend that you only select those phone numbers from your list that are allowed to activate this output.