Instructions / Assembly

7 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Installation
1
Installing the mounting plate
(concrete/brick walls)
2
Installing the mounting plate
(wood studs)
CAUTION: Avoid drilling near electrical wiring
and water pipes. The mounting system must be
attached to a weight bearing wall. Failure to
observe all safety precautions can result in serious
physical injury and/or property damage. Consult a
professional installer or call customer service if
you have any questions.
CAUTION: Do not drill into mortar between
bricks or into loose concrete.
CAUTION: Never drill into hollow brick.
□ Use the mounting plate (A) as a template to mark
the installation holes. Use a level to ensure the
plate is level.
□ Use a ¼ in. (6 mm) masonry drill bit to slowly drill
3 in. (76 mm) pilot holes. Then use a 3/8 in. (10
mm) masonry drill bit to expand the pilot holes.
□ Insert anchors (AA) into the holes. Ensure the
anchors are completely flush to the concrete
surface even if covered by a layer of joint
compound or other material.
CAUTION: Avoid drilling near electrical
wiring and water pipes. The mounting
system must be attached to a weight
bearing wall and must be installed directly
onto the center of the wood studs. Failure to
observe all safety precautions can result in
serious physical injury and/or property
damage. Consult a professional installer or
call customer service if you have any
questions.
CAUTION: Wood studs must be no smaller
than 2 x 4 in. in size.
□ Use a commercially-available stud finder to
locate the stud centers in the wall. Studs are
usually spaced 16 in. apart.
□ Use the mounting plate (A) as a template to
mark the installation holes. Use a level to
ensure the plate is level.
□ Use 5/32 in. (4 mm) wood drill bit to drill 3 in.
(76 mm) pilot holes.
AA
A
A
Incorrect
16 inch
Correct
Correct