Instructions / Assembly

7 HOMEDEPOT.COM/CETECH
Please contact 1-800-394-7519 for further assistance.
Installation
1
Installing the wall plate
(
wood stud
)
2
Installing the wall plate
(
concrete/brick walls
)
If you are installing this mounting system in brick
(concrete), proceed to step 2.
CAUTION: Avoid drilling near electrical
wiring and water pipes. The mounting system
must be attached to a weight bearing wall and
must be installed directly onto the center of the
wood studs. Failure to observe all safety
precautions can result in serious physical injury
and/or property damage. Consult a professional
installer or call customer service if you have any
questions.
CAUTION: Wood studs must be no smaller
than 2 x 4 in. in size.
□ Use a commercially-available stud finder to
locate the stud centers in the wall. Studs are
usually spaced 16 in. apart.
□ Use the wall plate (A) as a template to mark
the installation holes. Use a level to ensure the
plate is level.
□ Use a 5/32 in. (4 mm) wood drill bit to drill 3
in. (76 mm) pilot holes.
CAUTION: Avoid drilling near electrical wiring
and water pipes. The mounting system must be
attached to a weight bearing wall. Failure to
observe all safety precautions can result in serious
physical injury and/or property damage. Consult a
professional installer or call customer service if
you have any questions.
CAUTION: Do not drill in mortar
between bricks or into loose concrete.
Never drill into hollow brick.
□ Use the wall plate (A) as a template to mark
the installation holes. Use a level to ensure
the plate is level.
□ Use a ¼ in. (6 mm) masonry drill bit to
slowly drill 3 in. (76 mm) pilot holes. Then
use a 3/8 in. (10 mm) masonry drill bit to
expand the pilot holes.
□ Insert anchors (BB) into the holes. Ensure
the anchors are completely flush to the
concrete surface even if covered by a layer
of joint compound or other material.
A
A
BB
BB