Instructions / Assembly
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Item #1000 226 080
Model #XXXXXX
Use and Care Guide
Ethernet and Phone Wall Plate
Installation
1. Remove the old wall plate from the wall
outlet box.
2. If necessary, trim the cable jacket back
about 2 in., being careful not to nick any
wires inside.
3. If necessary, strip about ½ in. of
insulation off each wire.
4. For the phone line connections, attach
the four color-coded wires from the
phone line cord to the corresponding
color-coded wire terminals on the back of
the new wall plate.
5. For the Ethernet connections, attach each
wire to the specic terminal listed in the
chart below. Note that most residential
networks use the T-568B Standard.
6. Attach the wall plate to the wall using the
two screws located on the back of the
wall plate.
Pin Wall Plate Color Terminal T-568B Standard T-568A Standard
1 Blue White/Orange White/Green
2 Orange Orange Green
3 Black White/Green White/Orange
4 Red Blue Blue
5 Green White/Blue White/Blue
6 Yellow Green Orange
7 Brown White/Brown White/Brown
8 White Brown Brown