Instructions / Assembly
Instructions for Installing Speaker Post to Speaker:
Instructions for Attaching Speaker to Wall Plate:
Speaker NOT shown in the following pictures to provide a better view of the Speaker Bracket.
Page 2 of 2
Step 7:
Once the Speaker Post or additional
Mounting Plate is securely connected to
your speaker, attach it to the Adjustable
Link Section of the Speaker Mount. Use
the Allen Wrench to tighten the allen screw
securing the speaker to the Speaker
Mount.
Step 8:
To adjust the speaker angle, use the Allen
Wrench to loosen the joint at the center of the
Adjustable Link Section. Adjust to the desired
angle and re-tighten the joint to hold the
speaker at that angle.
If the joint is not securely tightened, the
speaker will begin to sag over time. The
speaker will also begin to sag if the weight limit
of nine pounds (9 lbs.) is exceeded.
This Speaker Mount is not designed for
speakers exceeding nine pounds (9 lbs.) in
weight.
Step 6
To mount the Speaker Post to your speaker, you must first determine the mounting method for your specific speaker. Choose
the appropriate mounting method for your particular speaker using Type A through Type E below.
There are several different screws included in this kit to work
with different speaker designs; you will not use all of the scr
ews
in the installation of this Speaker Mount.
Type E:
Speakers with Two Threaded Inserts
For this method, use the additional Mounting
Plate. Test fit to see which Machine Screw fits
your speaker’s threaded inserts. Use the two
correct Machine Screws to attach the
Mounting Plate to the back of the speaker.
Type D:
Wood Cabinet Speakers with no Factory Holes
For this method, use the additional Mounting
Plate. Carefully determine where to attach the
Mounting Plate on the back of the speaker and
mark the location to drill a pilot hole in the same
way as in Step 1. With a 3/32” bit, drill two holes
(no more than ½” deep) into the wood cabinet of
the speaker. Screw the Mounting Plate to the
back of the speaker with #12 x 3/4” Self-Tapping
Screws. DO NOT over tighten, this will strip the
screw hole and your speaker could fall off of the
Mounting Plate.
DO NOT use this method on speakers weighing
more than four pounds (4 lbs.).
Type B:
Most BOSE® Satellite Speakers
Use the M5 x 20mm Machine Screw with the
Plastic Washer as a spacer. For BOSE®
Lifestyle® 20 or Jewel Cube™ use M4 x 15mm
Machine Screw with the Plastic Washer as a
spacer. You MUST use the Plastic Washer
between the Speaker Post and speaker; this will
prevent the threaded insert from pulling out of
the s
p
eaker.
Type A:
Speakers with Threaded Insert
Test fit to see which Machine Screw fits
your speaker. If the correct screw does not
tighten down all the way, use the Plastic
Washer under the head of the screw as a
spacer.
Type C:
Speakers with Keyhole Slot
Pre-assemble the Post Mount using the
8-32 5/8” Machine Screw and 8-32 Round
Keyhole Nut. Insert the assembled items
into the keyhole opening of the speaker
and slide upwards into the keyhole slot.
Pull back gently on the Post Mount while
tightening the 8-32 5/8” Machine Screw. If
the Post Mount does not tighten down all
the way, use the Plastic Washer under the
head of the Machine Screw as a spacer.
Step 7
Step 8
Step 6: Type D Step 6: Type C
Step 6: Type E
Step 6: Type B Step 6: Type A
Step 6
Rev. 2