Instruction manual

GPIO Interface Programming

The MP700G can be ordered with a GPIO interface to allow customer interaction

with the player using push buttons or sensors. This allows the player to play a

video, playlist or ATSC tuner channel upon receiving a button press from the

GPIO inputs of a MP700 media player. Up to eight button inputs are supported.

One can easily conﬁ gure a wide variety of media to play for each button. An

‘idle loop’ video is played when the video triggered by the button is not playing.

The actions associated with each GPIO port may be assigned by using the Tools,

Button Setup menu in QSP700.

Creating the Push Button conﬁ guration ﬁ les with Quick Sign Pro:

Start QSP700 on a PC that resides on the same network as the target media

player, select the correct player, click on TOOLS and then click BUTTON SETUP.

Assign content via the drop down windows and then click Load Button Setup to

send the media and conﬁ guration ﬁ les over the network to the player. This may

take quite some time depending upon the size of the assigned media.

If you do not have network visibility to the player, the complete conﬁ guration and

media can be sent to a SD card plugged into your PC by pressing the Publish

button. This copies all necessary conﬁ guration ﬁ les, videos, pictures, layouts, etc.

and places them in the proper folders on the SD card. Simply take the newly

loaded SD card and plug it into the player and the unit will begin to play the

ﬁ l e s .

Note: This application was loaded separately on the MP500, but it is available at all times on

the MP700.