Instruction manual

RS-232
CONTROL
The unit includes a remote control for accessing the On
Screen Display. Press the MENU button to bring up the
OSD menu. Use the Arrow keys to navigate and press
ENTER to select an item. If you wish to exit the On
Screen Display, press MENU repeatedly until the OSD
is removed.
If you require a different Video output resolution, the TV
MODE button when pressed will toggle through several
options (Composite Only, 720p 60, 720p 50, 1080i
59.94, 1080i 60, 1080p 59.94, and 1080p 60.
In the blue button section you may use: PLAY, STOP,
FWD, REV, PREV, and NEXT. Pressing PLAY will
alternate between PLAY and PAUSE.
The numerical buttons may be used to enter a RF
channel on the MP700T unit. the format is: '041' to
tune in channel 4-1. To tne upper channels, use '331'
to select channel 33-1. These channel selections are
temporary and will not be kept on a power cycle. In
order to keep a RF channel, it must be programmed into
a playlist.
Note: Before the tuner may be used, it may be necessary to perform
a RF channel scan to populate the local channel table. An alternative
is to use the fi xed channel table. This can be set on the unit OSD
under Menu, Player Setup, Confi guration, Tuner Settings, and then
Tuner Channel Mode.
Remote Control
9
Detailed Player View
The MP700 may be ordered with or without the GPIO push button board. See
the GPIO section in this document for a description of the connector pinout.
8 PORT
PUSH BUTTON
INTERFACE