Technical Specs

www.erone.com - www.cdvigroup.com
The transmitter Erone type SETR128AM2 (Fig. 1) is a
very high security transmitter with GFSK modulation.
The high degree of security is ensured by a 128-bit
serial number, with a AES128 encryption and by a
proprietary “rolling code algorithm” that avoids the
risk of the scan and the subsequent retransmission
of the code copied. A special system keeps aligned
transmitter and receiver.
TRANSMITTER ERONE SETR128AM2
1
Introduction
Technical specications
Operating frequency ................433,92 MHz
Modulation ...............................GFSK
Erp: ..........................................150 ÷ 250 µW
Power supply ...........................3 Vdc
Battery type .............................CR2032 Lithium
Battery life................................24 months
Encoding system .....................Rolling code
Encryption................................AES128
Serial number ..........................32 bit
Range ( in open space) ...........150 - 250 m (*)
Dimensions: .............................61 x 36 x 16 mm
Weight .....................................30 gr.
The warranty period for this product is 24 months, beginning
from the manufacturer date. During this period, if the product
does not work correctly, due to a defective component, the
product will be repaired or substituted at our discretion. The
guarantee does not cover the plastic container integrity. After-
sale service is supplied at the factory.
Manufactured by :
CDVI Wireless SPA
Italy
IS-TMN128ERML Rev.1 - 25/2/2021
2
For memorizing the transmitter in the receiver,
follow the steps described in the manual of your
receiver.
Technical specications
3
Memorization on the receiver
5
Guarantee
To access the battery turn clockwise the battery door.
Place the 2 lithium CR2016 batteries inserting a part of
them under the door and taking care to push them just on
the internal ring plane.
NOTE: The disposal of the unloaded batteries must have
effected making use of the special containers.
4
Battery replacement
CR2032
Side (+)
Side (-)
Fig. 1
Fig. 2
FCC ID : PWJTM128
“The device complies with part 15 of the FCC Rules. Operation is subjected to the following 2 conditions: (1) this
device may not cause harmful interference and (2) this device must accept any interference received, including
interference that may cause undesired operation”.
Changes or modications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment. In cases where the manual is provided only in a form other
than paper, such as on a computer disk or over the Internet.

Summary of content (2 pages)