User Manual

The Installer’s Choice
8 - BATTERY ACCESS
To access the baery slide out the baery door as shown
in gure. Slide out the 2 old baeries and replace them
with the new ones [CR2016] respecng the polarity, with
the posive (+) side upward.
NOTE: Please dispose of the baeries properly according
to local laws and regulaons. Test proper baery instal-
laon by verifying that the LED illuminates when the
buon is pushed.
4 - NUMBERING
Each transmier is manufactured and sold with a die-
rent factory-set serial number.
6 - PROGRAMMING
The transmier must be programmed into your system
memory.
7 - OPERATION
A - Firmly depress the buon unl the small red BLUE
illuminates.
B - Aer the LED has illuminated, release the buon.
If the device you are aempng to acvate does not re-
spond, repeat steps A and B or consult secon 9
( Troubleshoong ) of this manual.
9 - TROUBLESHOOTING
PROBLEM SOLUTION
The system does not receive the
transmier signal.
The transmier LED is ON
Check to verify if the remote
is programmed into your system
The operang range is reduced
The transmier LED is blinking
Low baery : replace baeries
The system does responds.
The transmier LED is OFF
Baery empty : replace baeries
5 - MAIN COMPONENTS
This device complies with Part. 15 of the FCC Rules
Operaon is subject to the following two condions:
(1) This device may not cause harmful interference, and
(2) this device must accept interference received, including inter-
ference that may cause undesired operaon.
FCC ID : PWJS3RT
Noce
Any changes or modicaon to CDVI equipment not expressly
approved by CDVI could void the manufacturer’s warranty.
Buon A
Buon B
Buon C
Buon D
Baery door
2 x CR2016
Blue LED
Key ring
Slide to
open
CDVI 1637 Highway 440 West, Laval, Québec, Canada, H7L3W3
Tel: [phone], Toll Free Tel: [phone],
Fax: [phone], Toll Free Fax: [phone]
Manufactured by:
CDVI Wireless
Made in ITALY
WARRANTY
The warranty period for this product is 60 months, beginning from
the manufacturer date. During this period, if the product does not
work correctly, due to a defecve component, the product will be
repaired or substuted at our discreon. The guarantee does not
cover the plasc container integrity. Aer-sale service is supplied
at the factory.
IS-T15CDUK Rev. 0 15/1/2014
This EUT is in compliance with MPE for general populaon
/ uncontrolled exposure limits and it had been tested in
accordance with the measurement methods and procedures
specied in FCC 47 CFR § 1.1310 and 2.1091 .
To sasfy FCC RF exposure requirements for mobile transming devices,
a separaon distance of 20 cm or more should be maintained between
the antenna of this device and persons during device operaon. To ensure
compliance, operaons at closer than this distance are not recommended.
The antenna used for this transmier must not be co-located in conjuncon
with any other antenna or transmier.