Technical Specs
7
www.usautomatic.com
Deleting a single access code
Erasing all access codes
• Enter the Master Password.
• Enter “7”. If correct, 2 short beeps (if 1 long beep is heard, start over with rst step)
• Enter the Access Code to be deleted.
• Enter “7”.
• Reenter the Access Code to be deleted.
• Enter “7”. If correct, 2 short beeps (if 1 long beep is heard, start over with rst step)
• Enter the Master Password.
• Enter “7”. If correct, 2 short beeps (if 1 long beep is heard, start over with rst step)
• Reenter the Master Password.
• Enter “7”.
• Reenter the Master Password.
• Enter “7”. If correct, 2 short beeps (if 1 long beep is heard, start over with rst step)
Changing the Master Password
•
Enter the current Master Password
• Enter “8”. If correct, 2 short beeps (if 1 long beep is heard, start over with rst step)
• Enter the Master Password (up to 5 digits), if less than 5 digits, “#” is required.
• Enter “8”.
• Enter the Master Password again to verify.
•
Enter “8”. If correct, 2 short beeps (If 1 long beep is heard, start over with first step.
Setting the Master Password back to Factory Default: (11111)
•
Enter “11111.”
•
Enter “8” (long beep).
• Enter PUK code. (*)
• Enter “8”.
•
Enter PUK code to conrm.
•
Enter “8” (2 beeps).
Master password reset complete.
(*) : The 5 digit PUK code is located on a label in the battery compartment and must be
kept in a safe place by the end user.
Record Master Password here for future reference: _________________
Record PUK code here for future reference: _________________