Owner manual

8.PresstheALERTbuttontoturnthealertoff.
TheALERT SYMBOL (
)disappears
fromthedisplay
F. Oven Mode
1.PresstheMODEbuttontoswitchthetop
portionofthedisplaytoOvenmode.OVEN
appearsintheupperleftportionofthedisplay.
2.Inserttheprobeintothemeat;makingsure
thattheovensensorisfreeofallcontactwith
themeatorcookingsurfaces.
CAUTION:ProbemaybeHOTafteruse.Alwaysweara
heatresistantglovetotouchthestainlesssteelprobeor
sensorcableduringorjustaftercooking.Do not touch
with bare hands.
3.Gentlyclosetheovendooronthesensorcable
andinserttheplugintothejackontheleft
sideofthecase.Allowapproximately10to
15secondsfortheovensensortogetaccurate
temperaturereading.Theoventemperature
isdisplayedinbigdigitsunderOVENonthe
upperportionofthedisplay.
4.PresstheOVEN°Tbuttontosetthedesired
temperatureunderSETintheOVENportion
ofthedisplay.Pressandholdforfastadvance.
Note:Ovenalertrangeis86to572°F/30to300°C.
5.PresstheALERTbuttontoturntheaudio/
visualalerton,theALERT SYMBOL (
)
appearsonthedisplay.
6.Thealertsounds1beeppersecondwhenthe
oventemperatureexceedsthesettemperature
byonedegree.TheALERT SYMBOL (
)
andoventemperatureashandaCAUTION
SYMBOL (
)appearsonthelowerleftportion
ofthedisplay.
7. Pressanybuttontostoptheaudioalert.
TheALERT SYMBOL (
)andoven
temperaturecontinuetoashandthe
CAUTION SYMBOLremainsaslongasthe
oventemperaturereadingexceedstheset
temperature.
8.Iftheoventemperatureremainshigherthan
thesettemperaturefor2minutes,theaudio
alertwillactivateagain.Itwillcontinueto
reactivateevery2minutesuntilthealertis
turnedoffortheoventemperaturereading
dropsbelowthesettemperature.
9. PresstheALERTbuttontoturnthealertoff.
TheALERT SYMBOL (
)disappears
fromthedisplay.
G. Error Messages
TheDSP1incorporatesvisualdiagnosticmessages
asfollows:
1.HIindicatesthattheprobetemperatureis
higherthan572°F/300°C.
2.LOindicatesthat:
a.theprobetemperatureislowerthan
32°F/0°C,
b.thesensorcableisdisconnected,or
c. theprobeismalfunctioning.
3.Shouldthedisplayappearincorrectly,turnoff
andontoresetthethermometer.
Note:Cleanthethermometerprobebeforeeachuse.
Important: DO NOT LEAVE THERMOMETER CASE IN
HOT OVEN. IT IS NOT HEAT RESISTANT. DO NOT USE
PROBE IN MICROWAVE OVENS.
Important: ONLY THE PROBE CAN BE SUBMERGED IN
LIQUID. THE PROBE/SENSOR CABLE CONNECTION IS
NOT WATERPROOF.
Note on Induction Cooktops: Theinductioncooktop’s
magneticeldmayinterferewithdigitalthermometers.Ifthis
happens,brieyturnofftheinductioncooktoptogetadigital
thermometerreadingoruseadialthermometer.
Tip:Meatshouldbeallowedto“rest”for10to15minutesafter
itisremovedfromoven.Thisallowstimeforthemeat’sinternal
temperaturetostabilizeandthejuicestoredistribute.Thiswill
resultinaroastthatisbothjuicierandeasiertocarve.
CAUTION:Avoidkeepingthethermometertooclosetoobjects
thatcontinuouslygeneratehighheatforlongperiods(i.e.,hot
plate).Thiscancausethethermometertooverheat.
CE Note: This device could be sensitive to electrostatic
discharge.Ifelectrostaticdischargeormalfunctioningoccurs,
pleasere-installthebatterytoresetthisunit.