manual

5
Please note: You should ensure that there are no dishes in the upper basket when running a lower basket half-
load programme, and none in the lower basket when running an upper basket half-load programme.
If you have selected any extra function (3 in 1, prewash, half-load) for a programme, this function will automatically
be selected the next time the dishwasher is used. To cancel the selection of any extra function, press the specic
extra function button (5, 6 or 7) until the indicator light for that function goes out.
Starting a programme
• Press the Power button (the end of programme light will be switched on)
• Press the Programme Selection button until the required programme is shown on the display.
• If required, set the delay timer by pressing the Delay Timer button
• Once a programme is selected, the end of programme light will switch o.
• When you close the dishwasher door, the programme will start automatically.
Please note: The dishwasher stores the most recently used programme in its memory. To change the programme,
simply press the Programme Selection button.
At the end of a programme
If possible, do not open the dishwasher door once the programme has started.
At the end of a programme, the dishwasher will beep five times, and the end of Programme Indicator light will switch on.
Changing a programme
It is possible to change the programme if necessary once the programme has started.
• First open the door slightly to reduce the risk of water spillage.
• Press the programme selection button until the required programme is shown on the display.
• Then close the door. The dishwasher will begin the new programme from the point at which the old programme
stopped.
Cancelling a programme
It is possible to cancel the programme once is has started.
• First open the door slightly to reduce the risk of water spillage.
• Press and hold in the Programme Selection button for three seconds until the end of programme indicator flashes
and a “1” shows on the display.
• Then close the door. The dishwasher will run a drain cycle which will take approximately 30 seconds. Once this is
complete, the dishwasher will beep five times and the end of programme light will switch on.
Switching the dishwasher o
• Once the dishwasher beeps five times and the end of programme light switches on, the dishwasher can be switched
o by pressing the Power button.
• Then turn o the water tap and remove the plug from the power socket.
Please note: the dishwasher will automatically continue on the programme it has started if the door is opened or
in the event of a power cut.