Specifications

JCM Part No. 960-000058R_Rev. 2 © 2008, JCM-American Corporation
1
EBA-03 Bill Validator
Bill Acceptor Series
Section 1
1 GENERAL INFORMATION
This manual provides a general overview of the
advantages and options of the European Bill
Acceptor Validation Unit (EBA-03) pictured in
Figure 1-1. This first section is designed to help
you navigate through the manual with ease and
prov
ides the following information:
• Introduction
• Specifications
• Primary Component Parts
• Precautions
• Dimensions
• Country Codes.
In order to make operation of this device and make
navigation within this manual easier
, the following
illustrations were used within the text:
• Safety instructions, which need to be
observed in order to protect the operators and
equipment, have been written in bold text and
have been given the pictographs:
• Special Notes, which effect the use of the Bill
Validator, have been written in italic text and
have been given the pictograph:
• Steps, requiring the operator to perform
specific actions are given sequential numbers
(1., 2., 3., etc.).
Introduction
The JCM EBA-03 Bill Validator head is designed
for international platforms that accept currency
62mm to 72mm in width and allows lengthwise
insertion in all four directions.
The EBA-03 contains:
• Custom Sensor Technology
• 2 Mb of EPROM Memory
• Denomination DIP Switch Selections
• Pulse or Serial Interface Capabilities
• Two Second Validation Speed
• Easy Access Serviceability
• CE Approval.
Figure 1-1 EBA-03 Bill Validator