Specifications

JCM Part No. 960-000058R_Rev. 2 © 2008, JCM-American Corporation
22
Section A EBA-03 Bill Validator
T EST N O . 1 T RANSPORT M OTOR F ORWARD
R
OTATION T EST
The first test is the motor speed test in a
forward direction.
1. Set the initial DIP Switches accordin
g to the
Figure A-4 illustration.
2. With the power turned off to the VM-450, set
DS-1
, Switch #1 to the ON position.
3. Turn on the VM-450 power. The BSY and
STKF lig
hts will come on.
4. Put DS-1, Switch #1 in the OFF position.
Th
e BSY light will go out. The motor will
rotate in a forward direction. One of three
lights on the VM-450 will indicate the motor
speed (See Figure A-5).
T EST N O . 2 T RANSPORT M OTOR R EVERSE
R
OTATION T EST
The next test is the motor speed test in a reverse
direction.
1. With the VM-450 power turned OFF, set
DS-1 Switch #1 ON and apply power.
2. Set DS-1, Switch #2 to the ON position as
show
n in Figure A-6.
3. Turn DS-1, Switch # 1 OFF. The BSY light
will go ou
t, and the motor will rotate in the
reverse direction. One of the three previously
described lights on the VM-450 will indicate
the motor speed rate (Review Figure A-5).
T EST N O . 3 A CCEPTOR S ENSOR T EST
This test checks the acceptor head sensors status.
Set the initial DIP Switches according
to the Figure
A-7 illustration.
1. Turn off power to the VM-450.
2. Turn DS-1, Switches #1 and #3 to ON.
3. Turn the power to the VM-450 ON.
4. Turn DS-1, Switch # 1 OFF to begin run-
ning the tests.
5. Slowly slide the White Test Paper into the
Acceptor while follo
wing the steps listed in
Figure A-8.
When the White Paper is inserted into
the bill
insertion slot, the ”F” Sensor shown in Figure A-9
is the first to detect it. This detection will turn the
VEND
1 LED ON. As the White Paper is inserted
farther into the Acceptor Head, the remaining
sensors will also detect its travel, and the appropri-
ate LEDs on the VM-450 will sequentially light
(See Figure A-9).
Figure A-4 Transport Motor Forward Rotation
Test DIP Switch Settings
Figure A-5 EBA Test #1 & 2 LED Indications
ABN LED ON
Indicates a
Fast Motor Speed
BSY LED ON
Indicates a
Correct Motor Speed
VEND 1 LED ON
Indicates a
Slow Motor Speed
Figure A-6 Transport Motor Reverse Rotation
Test DIP Switch Settings
CAUTION: Do not attempt this test
using a currency note! It is
recommended that the test be
performed with the special White Paper
normally used to calibrate the sensors.
Figure A-7 Acceptor Sensor Test DIP Switch
Settings
Figure A-8 EBA Test #3 Lit LED Indications
Push the ACK
button to test the R,
C, & L Sensors
Sensors E and B
have detected the
White paper
Sensors CR and CL
have detected the
White paper
NOTE: Move the Enable/Disable Toggle Switch to the
“ENABLE” Postion to test Sensors E and B.
NOTE: The Red STKF light will be lit (ON)
during the tests.