Specifications

JCM Part No. 960-000058R_Rev. 2 © 2008, JCM-American Corporation
12
Section 3 EBA-03 Bill Validator Disassembly / Reassembly
10. Remove the Sensor Cover by removing the
two retaining screws shown in Figure 3-7 a.
11. .Remove the Lower Sensor Board by discon-
necting the 30-pin board connector
(See Figure 3-8 a), and the 2-pin connector
coming from the motor (See Figure 3-8 b).
12. Remove the two (2) screws shown in Figure
3-8 c.
13. Remove the Lower Sensor Board Cover by
by removing four (4) circ
uit board retaining
screws (See Figure 3-9 a).
14. Remove the two screws securing the motor
cover from the lower assembly and remove
the
motor, gears and drive belts from th
e
assembly (See Figure 3-10 a).
15. Lift the motor up and out of the frame
(See Figure 3-11).
Reassembly Procedure
To reassemble, reverse the preceding procedure.
Figure 3-6 CPU Board Removal
Lift the Board
Up and Off
the Frame
Figure 3-7 Sensor Cover Screw Removal
a
Figure 3-8 Freeing the Lower Sensor Board
a
b
c
Figure 3-9 Lower Sensor Board Cover Removal
a
Figure 3-10 Motor Cover Removal
a
CAUTION: There is a small, white ball
bearing located in a cup at the end of the
drive shaft that could fall out when the
motor is removed. Carefully remove it,
and store it in a safe place for reassembly.
Figure 3-11 Motor Removal
Lift up
and Out