Specifications

VM-Series Deployment Guide 39
Set Up a VM-Series Firewall on the Citrix SDX Server Secure North-South Traffic with the VM-Series Firewall
The following table includes the basic configuration tasks you must perform on the VM-Series firewall. For
firewall configuration instructions refer to the PAN-OS documentation. The workflow and configuration on
the NetScaler VPX is beyond the scope of this document; for details on configuring the NetScaler VPX, refer
to the Citrix documentation.
Topology Before Adding the VM-Series Firewall
Topology after adding the VM-Series firewall
Set up the VM-Series Firewall Before the NetScaler VPX with Virtual Wire Interfaces
Step 1 Install the VM-Series Firewall on the
SDX Server.
On the SDX server, make sure to enable Allow L2 Mode on the data
interface. This setting allows the firewall to bridge packets that are
destined for the VIP of the NetScaler VPX.