Specifications

37
Press the “ok” button (B9) to confirm the temperature selected.
Press the button (B6) to exit the menu.
Setting Water Hardness
The coee maker is factory set to provide a descale warning after a
certainperiodofuse.Thiscanbeadjustedtomatchyourlocalwater
hardness as follows:
Removethe“TotalHardnessTest”strip(suppliedwiththemachine)
from its packaging, dip it fully into fresh tap water for a few seconds,
then remove and wait about 30 seconds (until it changes colour and
forms red squares). Note the number of red squares visible on the
test strip.
Onthecoeemaker,presstheSettingsMenubutton(B2)toenter
the menu then press the “+” & “-“ buttons (B7) and (B8) to select the
“WATERHARDNESS”function.
Press the “ok” button (B9) to confirm.
Press the “+” & “-“ buttons (B7) and (B8) until the number coincides
with the number of red squares on the test strip (e.g. if there are 3 red
squaresontheteststrip,selectthemessage“WATERHARDNESS3”).
Press the “ok” button (B9) to confirm.