Specifications

31
  Squeezethetworedreleasebuttonsinwardsand
at the same time pull the brewing unit outwards (fig.
29).
Important: Do not use washing up liquid to clean
the brewing unit. It would remove the lubricant
applied to the inside of the piston.
Soakthebrewingunitinwaterforabout5minutes,thenrinse.
After cleaning, replace the brewing unit (A5) by sliding it onto the
internalsupportandpinatthebottom,thenpushthe“PUSH”symbol
fully in until it clicks into place.
Note:Ifthebrewingunitisdiculttoinsert,ensurethepistonisfully
inserted by pressing it firmly from the bottom and top as shown here:
Once inserted, make sure the two red buttons have snapped out.
Replacethedriptrayandwastecoeecontainer.
Close the service door.