Technical data
Installation:
1. Align the spout with the centre position of the handle lever on the valve
2. Screw in the fixing stud (E) into the base of the tap (A)
3. Pass the base column (B) over the fixing stud (E) to the base of the tap body (A)
4. Place the upper seal (D) onto the base plinth (C) , the place both these parts onto the base column (B)
5. Screw the hot and cold flexible tail pipes (J) into the base of the tap body (A) , note: the hot water should be connected to the left hand side of the
tap when viewed from the front.
6. Place the mixertap onto the sink or worktop and pass the tail pipes (J) and studded rod (E) through the taphole. With the tap in place check that the
tail pipes (J) meet the hot and cold water feeds. If further adjustment to the plumbing is required do this now
7. If fitting the tap to a stainless steel sink, the white triangular stabiliser (F) can be placed where shown to help to stabilise the weight of the tap.
8. Pass the rubber horseshoe (G) and then metal horseshoe (H) over the fixing stud (E) and around tail pipes (J).
9. Fasten the fixing nut (I) securely onto the fixing stud (E) fixing the tap into its correct location.
10. Connect the Hot & Cold water tail pipes (J) to the water supplies using ½” BSP x 15mm compression fittings or similar.
After installation:
Once you have visually checked the new fittings and
connections, ensure that all taps are closed except
the new mixer tap, which should be left open. Turn
on the water supply at the mains stop cock. As the
system starts to refill, check carefully for leaks.
Once you are fully satisfied that there are no leaks,
turn on the water heating.
Clean the tap to remove any marks created during
installation as instructed then replace the bag that
has been provided to protect the tap until it is ready
for use.
Key: Description: Qty.
A Tap body 1
B Base column 1
C Base plinth 1
D Upper seal 1
E Fixing stud
1
F
White triangular stabilizer
(for stainless steel sinks only)
1
G Rubber horseshoe 1
H Metal horseshoe 1
I Fixing nut 1
J
Hot / cold water flexible tail pipes
(with integral non return valves)
2