Specifications
8
To switch the instant hot water heater on or o
Touch the “On/O” key (A) once to switch the water heater on.
Touch the “On/O” key (A) once again at any time to switch the water
heater o
To set the water temperature
Touch the “Temperature” key (C) several times to scroll through the
available temperatures. When the “Set temperature” indicator (G)
shows the temperature you want, touch the “Confirm” key (A) once to
confirm this setting. If the “Confirm” key (A) is not touched within five
seconds the temperature setting will revert back to its previous level.
Note:
• At all times, the “Actual temperature” indicator (D) shows the actual
temperature of the water in the reservoir/heater unit.
• When the water is heating the “Heating” indicator (F) will illuminate
and the “Heating” display (H) will animate.
• When the water in the reservoir/heater unit is at the set temperature
the “Hot” indicator (E) will illuminate and the “Heating” display (H) will
illuminate constantly
• If the “Set temperature” indicator flashes “99” this means that
the heater is energised but there is insucient water in the
tank. Touch the “On/O” key (A) to switch o the water heater
and prime the tank (refer to “priming the installation” in the
installation section below).