Specifications

12
Installation
It is the installer’s responsibility to ensure that your 3 in 1 instant
hot water tap is fitted in accordance with all prevailing national
standards and local water byelaws.
It is important to ensure that the plumbing part of the installation
is completed and has been tested to ensure it is free of leaks,
before any electrical connection is made to the unit.
Do not install the appliance in rooms where the temperature may
drop to 0°C or lower.
If the tap or reservoir/heater unit have been stored prior to
installation in a place where the temperature could have fallen
below 0°C they should be allowed to acclimatise at room
temperature for a minimum of one hour prior to connection to a
water supply.
Preparation for installation
• Before installing the 3 in 1 instant hot water tap it is essential to
thoroughly flush through the supply pipes in order to remove any
remaining solder, swarf or impurities from your system. Failure to
carry out this simple procedure could cause problems or damage to
the workings of the 3 in 1 instant hot water tap.
• We strongly recommend installing particle filter strainers and
isolation valves to both the hot and cold feed pipes in an accessible
position. This will help to prevent premature failure and ease any
future maintenance.