Specifications

11
Problem Possible Cause Remedy
Water drips from the
3 in 1 instant hot water
tap spout.
The expansion
chamber isn’t
draining the system
correctly due to
very small draw o
of water.
The spout is
blocked.
Draw o 0.5L of water to
clear and prime the system.
Avoid drawing o less than
150mL of water at a time.
Remove and clean the
aerator on the tap.
Slow Flow from the
spout.
The water filter may
be clogged from
impurities in the
inlet mains water.
The water filter must be
changed every 6 months.
Failure to do this will void the
guarantee.
Water does not flow
immediately.
The 3 in 1 instant
hot water tap is
design for non-
pressurised
operation so there
will be slight delay
before the near
boiling water starts
to flow.
This is not a fault.
Note that after a large volume
of water has been drawn o
there may a slightly longer
delay in the water appearing
from the instant hot water
spout.
No Water Flows. Water Valves have
been turned o.
Inlet Pipes have
become twisted or
blocked.
Turn on all the water valves
Ensure the pipes are not
twisted or kinked and
restricting flow.
Remove and clean the
aerator.