Specifications

50
GENERAL
– The connection to the electrical net-
work must be carried out by qualified
personnel and must be according to
existing norms.
– The appliance must be connected to
the electrical network verifying above
all that the voltage corresponds to the
value indicated on the specifications
plate and that the cables section of
the electrical plant can bear the load
which is also indicated on the plate.
– If the appliance is supplied without a
power supply plug and if you are not
connecting directly to the mains, a
standardized plug suitable for the load
must be fitted.
– The colours of the wires in the appli-
ance power cable may not corre-
spond with the colours marked on the
terminals of your electrical plug. The
plug should always be wired as fol-
lows:
● connect the green/yellow wire to
the terminal marked with the letter
E or the earth symbol or coloured
green/yellow;
● connect the blue wire to the termi-
nal marked with the letter N or
coloured black;
● connect the brown wire to the ter-
minal marked with the letter L or
coloured red.
The connection of the appliance to
the grounding unit is mandatory.
The manufacturer declines every
responsability for any inconve-
nience resulting from the inobser-
vance of this condition.
Before effecting any intervention
on the electrical parts the appli-
ance must be disconnected from
the network.
– The bi-polar plug must be connected
to an outlet connected to the ground-
ing unit in conformity to security norms.
– If the oven is to be connected direct-
ly to the mains, it must be placed with
an omnipolar switch with minimum
opening between the contacts of 3
mm between the appliance and the
mains.
– The power supply cable must not
touch the hot parts and must be posi-
tioned so that it does not exceed
75°C at any point.
– Once the oven has been installed, the
switch or socket must always be
accessible.
– If the power supply cable is damaged
it must be substituted by a suitable
cable available in the after sales ser-
vice.
N.B. For connection to the mains, do
not use adapters, reducers or branch-
ing devices as they can cause over-
heating and burning.
If the installation requires alterations to
the domestic electrical system call an
expert.
He should also check that the socket
cable section is suitable for the power
absorbed by the appliance.
ELECTRICAL SECTION
11