Specifications

14. Wipe all protective shipping oil and grease from
Machine. (Clean rust preservative from way bars
and any other bright metal surfaces.)
15. If applicable: Position optional coolant system on
right side of base.
LUBRICATING SYSTEM
The machine is equipped with an automatic grease
lubricating system.
Grease Reservoir is filled at the factory with Sunnen
90123 (Kluberplex #BEM34-132 or its equivalent)
(see Figure 1-6). System is equipped with a
Pressure Switch, which flashes a warning on the
operator display screen when the level/pressure
drops below minimum requirement.
ELECTRICAL
All wiring is to be performed by a competent, Licensed
Electrician in accordance with all local, state, and
federal codes and regulations; along with any special
information provided on machine nameplate or
electrical specification plate (
see Figure 1-7).
CAUTION
This machine was wired for 460VAC. If it is to be
run at 400VAC the taps on the control transformer 1T
must be changed. All wiring is to be performed by a
competent, licensed electrician in accordance with
all local, state and federal codes and regulations.
FAILURE TO COMPLY CAN RESULT IN PERSONAL
INJURY AND DAMAGE TO THE MACHINE.
WARNING
All wiring and electrical equipment service should
be performed by authorized personnel ONLY.
CAUTION
Do not attempt to connect machine if supply voltage is
not within acceptable limits as noted on nameplate or
electrical specification plate. If supply voltage is not
within these limits MACHINE WILL BE DAMAGED.
Verify supply voltage is same as voltage on Machine
Nameplate or Electrical Specifications Plate.
ELECTRICAL CONNECTION
A pre-drilled hole has been provided in Electrical
Enclosure for Electrical Supply Cord (not supplied).
Connect Cord as follows (
refer to Figure 1-7).
WARNING
Residual Voltage exists for 2-3 minutes after
Master ON/OFF Switch is turned OFF. Before
working inside Enclosure, wait for all fans to stop
running to allow drives to discharge.
1. Unlock Door to Electrical Control Enclosure.
Loosen Safety Latches on door(s) to enclosure,
using a screwdriver.
3
FIGURE 1-7, Electrical Connection
NAMEPLATE
FIGURE 1-8, Coolant System (opt.)
MASTER
ON/OFF
SWITCH
L3
L1
L2
GND
GRN
ELECTRICAL
DISCONNECT
BLOCK
SUPPLY
CORD
FIGURE 1-6, Lubricating System