Specifications

• Key in desired value using key pad - Press OK to
accept.
BORE LENGTH: 3.50000
• Select Material - Press OK to accept.
MATERIAL: Tool Steel
• Select Hardness - Press OK to accept.
HARDNESS: 2
7. Press NEXT to continue with setup: (Follow
directions on display screen.)
• Select Tool Family – This will display your tool
selection options. (Select tool family.)
CV
• Select Tool.
CV-3305A (CK-3035A)
8. Press NEXT to continue with setup: (Follow
directions on display screen.)
• Under Honing Options click in the boxes to
activate Pre & Post Hone Spindle Rotation. This
will activate grayed out buttons to the left.
• Honing Parameters are calculated based on pre-
programmed information. Only change these values
if necessary.
NOTE: To Change: Click on parameter you wish to
change, key in value, and press OK.
9. Press NEXT to continue with setup: (Follow
directions on display screen.)
• Under Feed Options clicking in the box will
activate Rapid Until Load button to the left and gray
out Amount Before Start button.
• Pre-Honing Feed Parameters are calculated based
on pre-programmed information. Only change these
values if necessary.
10. Press NEXT to continue with setup: (Follow
directions on display screen.)
•
Select Honing Feed Rate 1, key in 0.02, and press OK.
• Leave Feed Options alone at this time.
11. Press NEXT to continue with setup: (Follow
directions on display screen.)
• Under Feed Options click in boxes for Sizing and
Sparkout. This will activate the related buttons to
the left.
• Leave Crosshatch Options alone at this time.
12. Press NEXT and select install new tool.
13. Press NEXT and follow directions on display
screen.
14. Once Tool is installed press NEXT and then
press YES on the window that says “Teach Tool
Size (Snug).
15. Set tool SNUG diameter by moving tool around
in bore, while using handwheel, expand tool (CW)
or retract tool (CCW), until tool feels snug in bore.
16. Press TEACH to set Snug Diameter. Box to
right will turn green and display “the snug size is
set.”
17. Press NEXT and continue to follow directions
on display screen for setting stroke.
18. Under Loading Method select Manual.
19. Press FINISH when stroke is set.
20. Press Yes to save setup.
21. Select location to save file. Name the File. Then
Press Save.
22. Press F10 to access Run Menu.
23. Install workpiece in fixture.
24. Press F2, Run Settings.
25. Click on Machine Tab.
26. Toggle ON Coolant (Green).
27. Under Cycle Mode click Single.
28. Press APPLY and then press OK.
29. Close all Guards.
30. Press CYCLE START button and run a honing
cycle.
31. Open Guards.
32. Remove and check (gage) workpiece(s).
• To edit: Press F4 Edit Setup. Then press F4 to edit
Part Specifications or F5 to edit Column A Setup
(Machine).
33. Press OK when finished.
34. Press F10 to return to Run Menu.
35. Load parts.
36. Continue Honing.
SAFE SHUTDOWN (Turning Machine Off)
To turn OFF the Machine properly, DO NOT just turn
off the disconnect switch. Please follow the following
steps:
1. Using the Mouse, left click on the ⌧ that is located
in the upper right corner of the screen.
2. This will display the exit password dialog box. Enter
“shutdown” (all lower case) and then click on he OK
button.
3. After a few moments, a dialog box will come up
on the screen saying that it is safe to turn off the
computer. At this time, you can turn off the
disconnect switch
.
17