Specifications

4b. The Transverse Column Assembly which allows
the Spindle Carriage to move left or right to align
Spindle with bore. It is powered by
4c.
The Spindle Motor which by way of a belt, drives
4d. The Drive Tube which imparts stroking and rotational
motion from spindle to honing tool. Houses feed rod.
4e. A Ball Screw Stroker Assembly located inside of
Column provides stroking power to Spindle Carriage.
5. Workholding Fixture (opt)
6. The Adjustable Coolant Lines allows manual
regulation of honing fluid flow through the
7a. The Sump Pump pumps coolant from the
machine base reservoir.
7b. A Coolant Interface allows an optional coolant
system to be attached to the machine.
8. A Coolant System (opt) can be added to ensure
debris is removed from coolant.
9. An automatic Lubricator provides grease to the
major components of the machine.
OPERATOR CONTROLS
For the location and function of the operator
controls
refer to Figure 2-2 and Table 2-1.
SAFETY SYMBOLS
For a description of safety symbols used on this
machine,
refer to Table 2-2.
WORKHOLDING FIXTURE
Install and align Optional Workholding Fixtures
according to instructions packaged with fixtures
supplied for your particular application.
NOTE: Fixtures used on these machines are custom
made for each job. Follow installation and alignment
procedures packaged with your fixture.
HONING TOOL
Refer to Sunnen Industrial or Automotive Honing
Supplies Catalogs for all your honing needs
CAUTION
Use of tooling other than Sunnen tooling will render
all of features of computerized honing system
useless, due to fact that machine and all its
parameters are calibrated to Sunnen Tooling only.
NOTE: On SETUP screen, there is a TOOL option.
This option allows operator to select type of tool that
will be used. The correct tool family needs to be
selected in order for feed system to operate properly
Sunnen offers a wide verity of tooling options within
the diameter range of this machine. Including:
CK/CV-Series Hone Heads 51-203mm
GHSS/GHTS-Series Hone Heads 38-141mm
The following options require a mandrel adapter:
P20/28-Series Hone Heads 19-152mm
MPS-Series Hone Heads 50-216mm
9
SYMBOL DESCRIPTION FUNCTION
Warning Label Warns that an electrical hazard exists.
Label Designates this machine is “CE” compliance .
Warning Label Warns that no drilling is allowed. Drilling any new holes may void warranty.
Warning Strip Warns that a physical hazard exits , and that proper precautions should be taken.
Caution Label Warns that a finger hazard exists. Do not touch while
Moving Parts stroker is operating.
Warning Label Warns that power must be OFF when belt guard is opened,
(Light) to prevent injury.
Warning Label Warns that safety glasses should be worn at all times when
(Safety Glasses) operating this machine.
Warning Label General Warning.
TABLE 2-2, Safety Symbols