Specifications

GENERAL
Consult this section when preparing the Machine for
operation.
MAJOR COMPONENTS
Consult the following figure for location of major
components on your machine, (
see Figure 2-1).
1a. The Machine Base is equipped with
1b. Leveling Bolts for stabilizing Machine and
1c. Stainless Steel Guard Doors.
2a. Electrical Enclosure. Located on rear of Machine.
2b. Column Enclosure. Located on rear of column.
3a. The Operator Station houses all electronic
hardware and software for hone control. It is also
main operator interface with machine.
4a. The Spindle Carriage is mounted on
7
FIGURE 2-1, SV410 Honing Machine
SECTION 2
PREPARING FOR OPERATION
- 1A -
MACHINE
BASE
- 1B -
LEVELING
BOLTS
- 4A -
SPINDLE
CARRIAGE
- 4E -
BALL SCREW
STROKER
ASSEMBLY
- 4B -
TRANSVERSE
ASSEMBLY
- 7A -
SUMP PUMP
- 4D -
DRIVE TUBE
- 3A -
OPERATOR
STATION
- 1C -
STAINLESS
STEEL DOORS
- 4C -
SPINDLE
MOTOR
- 8 - (OPT)
COOLANT
SYSTEM
- 5 - (OPT)
WORKHOLDING
FIXTURE
- 2B -
COLUMN
ENCLOSURE
- 2A -
ELECTRICAL
ENCLOSURE
- 9 -
LUBRICATOR
- 6 -
COOLANT LINES