Specifications

4
Before First Use
You must allow the fridge to settle for at least twenty four hours
prior to switching the power on.
It is recommended that you clean the interior of the appliance prior to
first use, using a solution of bicarbonate of soda and warm water and
then thoroughly dry the interior.
The fridge may have an odour to it at first use. This will disappear as
the appliance cools.
Do not load the appliance with food until it reaches the required
temperature.
Please note:
The appliance will work continuously until it comes down to the correct
temperature.
If the appliance is switched o, you should allow five minutes
before switching it on again to prevent unnecessary damage to the
compressor.
The fridge and freezer shelves can be moved according to storage
requirements.
To move the shelf, pull the shelf outwards until the shelf stops
(approximately one third out) then lift up the front section slightly and
pull the shelf out. To replace, slide the shelf back into the slot, and then
lower the front section before pushing fully back into position.
fig. 1