Specifications

3
Important
• Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.
• This is a household appliance, which is produced in accordance with the national standard. It is intended for food
storage only, not for storage of blood, medicine and biological products.
• To prevent risk of fire, keep the appliance away from petrol or any other inflammables.
• To prevent risk of electromagnetic interference or other accidents, do not place a microwave oven on top of the
refrigerator or use any electric appliance inside the refrigerator.
• Do not allow children to play with or near the appliance.
• The internal surface of freezer compartment is very cold when the appliance is running. Do not touch the surface
especially when hands are wet.
• Do not splash water onto the appliance. Keep it away from places of high humidity that may have adverse eect on
the electric insulation performance.
• This appliance is designed to be used in ambient temperatures between 16 and 38˚C. Use outside of this range may
cause the appliance to fail.
In the event of a power failure, leave the door closed as much as possible to maintain the internal working temperature.
Should the power failure continue for a prolonged period, you should take steps to protect the contents of the appliance
against a rise in temperature. The appliance will remember the selected temperature settings and revert to these
settings once the power is restored.
IMPORTANT: Remove the lid from the top of the ice dispenser inside the freezer door prior to first switching on the
freezer.
On first use, the icemaker will begin working once the freezer has reached the required temperature. This can take up
to 6 hours.
If ice will not be required, touch the ice o key on the control panel to switch o the ice maker.
On first connection, select the water option using the dispenser selection key on the control panel. Place a jug or other
suitable container under the dispenser nozzle and push the switch for two to three minutes, or until water starts to
dispense.
The pipes must be cleaned through on first use to remove any impurities in the system after installation. To do so, place
a jug or other suitable container under the dispenser nozzle and push the switch to start the dispenser. Dispense water
for approximately three minutes and ice for approximately one minute, and then dispose of the water and ice dispensed.