Specifications

10
Care and Cleaning
IMPORTANT: Turn o the ice maker using the ice o key on the control panel before removing the ice
compartment for cleaning.
Always disconnect the appliance from the power before any cleaning or maintenance.
• The refrigerator and freezer sections should be cleaned using a solution of bicarbonate of soda and lukewarm water.
• Do not use abrasive products or detergents. After washing, rinse and dry thoroughly.
• Clean the shelves and balconies separately by hand using soap and water. Do not put them in the dishwasher.
• The evaporating tray and water drain hole (at the back of the refrigerator compartment) should be cleaned
periodically to prevent the defrosted water from collecting inside the refrigerator compartment. The drain plug can
be used to clear the drain hole.
• Once cleaning is complete, then reconnect the power.
• If the appliance is not used for prolonged periods of time, unplug and clean the appliance. The doors should be left
slightly open to prevent the formation of mildew and smell.
This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places.
• The plug should be fully accessible at all times.
• To ensure the appliance is level, you should use the height adjustable feet at the front of the appliance.
• The appliance must be installed with adequate ventilation. Ensure that there is 10cm clearance above the appliance,
and that there is space between the rear of the appliance and the wall.
The water filter
The water filter should be replaced every six months approximately to ensure best performance. This duration may be
reduced depending on the water quality and usage. When replacement is required, the
symbol will show on the
display.
To order a replacement filter, contact CDA Customer Care.
The filter is located in the top right of the fridge compartment.
When removing the filter for replacement, place a container underneath the filter to catch any residual water which will
fall.
To remove the filter, turn the filter to the left then lower out of position. To replace, push the filter upwards, and then turn
it to the right.