User`s guide

CDA 7 Maintenance Manual

5-4 77 A7 48UU Rev03

3. Perform the following two commands:

− FIRMGEN,

− BLOAD on a media intended for the next initialization of the new

configuration.

For more information, refer to Basic Models in Appendix A, Software Release

and CDA 7 Configurations (9 GB Disks), or in Appendix D, Software Release

and CDA 7 Configurations (18 GB Disks).

IMPORTANT:

Send the Lap-Top configuration to the Bull Competence Center.

5.1.2 Step 2

Reminder: If you know the type of add-on as well whether any cards are to be

moved, estimate the time required for the operation, and calculate the system

availability to carry it out. (Additional WSPs, cable installation, CDA subsystem

cards and disks, etc.)

NOTE:

In case of Coupled Systems, contact the Bull Competence Center and request

assistance with step 3.

5.1.3 Step 3

For coupled system configuration, step 3 takes place with the collaboration of Bull

Competence Center. The CDA 7 portion takes place as follows:

1. Copy the new file IMPL.BIN to the PC disk.

2. Stop use of the system by GCOS.

3. Disable SA (SCSI Adaptor) and DA (Disk Adaptor).

4. In the main menu, highlight the Automatic Install option or enter B.

5. Select the Disk option and verify configuration.

6. Select the B=Load and Save option to validate the new configuration to the

subsystem.

7. Enable SA (SCSI Adaptor) and DA (Disk Adaptor).

8. Hand the system back to GCOS.

9. Launch the VTOC command for the new disk (Selective VTOC).