User`s guide

CDA 7 Maintenance Manual
5-2 77 A7 48UU Rev03
5.1 DPS 7000 Add-on Hardware
The introduction of standard configuration files has greatly simplified Add-Ons.
This chapter describes how to perform such an add-on to a CDA 7 cabinet already
installed in the configuration. Perform the required operations in the order shown
in Figure 5-1.
Step 1
Step 2
Under GCOS:
1. Build a new CONFIG_FILE.
2. Send the "LABEL" command.
3. Note the name "Dxxxx-xx.BIN"file.
4. BLOAD on a media.
1. Plan the operation with the customer.
2. Alert the BCC (Date, type of add-on, etc.)
3. Wait the planned day of operation
Step 3
"D" day:
- Proceed to Add-on operation
Step 4
Init GCOS (CONFIG, RESTORE/RESTART
COLD, etc.) with new BLOAD.
Figure 5-1. Add-On Procedure Overview