User`s guide

CDA 7 Maintenance Manual
F-18 77 A7 48UU Rev03
F.3.7 Verifying the CDA 7 Configuration
Bull has defined a number of standard models, for which the configuration
(number of disks, number of DIRECTORS, etc.) is precisely determined.
In order to initialize the subsystem correctly, the PC must contain a file describing
the installed configuration; it is obvious that this file describes one of the standard
configurations (or basic models) specified in Bull/EMC agreements.
This file is called IMPL.BIN in directory C:\SYMM4
In order to proceed this "Automatic Install" command, the PC disk must contain
the IMPL.BIN corresponding to the delivered configuration. The name of the
binary file is given in the configuration descriptions in:
• Appendix D, Software Release and CDA 7 Configurations (18 GB Disks for
5330 and 5630), or
• Check with your Bull Competence Center.
F.3.7.1 List of Available BIN Files
For the list of available BIN files:
System with 18 GB disks See paragraph D.2 (Appendix D).
F.3.7.2 Modifying the Configuration
If the configuration is incorrect, you can ask the Bull Competence Center:
• To download a new configuration file.
• If present on site, to load the configuration file from a standard configuration
diskette.
If necessary, copy the file under MS-DOS using the following procedure:
1. Press Escape to exit from the main menu. The C:\SYMM4 prompt is
displayed.
2. Rename the IMPL.Bin file as IMPL.Old.
3. Copy the IMPL.Bin file.
4. Return to the main menu:
C:\SYMM4 > LOOP