User`s guide

Installing the CDA 7 5630 with Microcode Release 5265
77 A7 48UU Rev03 F-7
The following screen is displayed:
Figure F-3. PC Configuration - 2
This screen displays the standard values of the parameters. If you select the
Parallel port:
• RS-232 MUX, the following line displays: MUX "local" director: 1 and the
cursor goes automatically to this line. Use the RS-232 port when you change the
DA-01. To do this, refer to Replacing the DA#1 from the Lap-Top Access
Change earlier in this document.
• Not in use, the following line is Use only black and white?
You navigate in the screen by pressing the Up/Right/Down/Left keys. Select each
parameter in turn to set the values shown above and then press ENTER.
• You can use the F10 key at any time to quit and save modified/displayed values.
• You can use the ESC key at any time to exit from the screen ignoring all
modifications.
• Values shown between quotes are those active when you enter the screen or
chosen in the modification sequence.