Specifications

5
Fig. 3
Care and Maintenance
Changing the charcoal lter (re-circulating only)
When the display ashes alternating the speed selected with the letter F, the
charcoal lters must be replaced. After the charcoal lter has been replaced,
the electronic memory must be reset by touching key A for approximately
ve seconds, until the letter F stops ashing.
To attach a new charcoal lter, rst open the cover panels and the lters as
described above. Then oer up the charcoal lter into the frame as shown in
gure 3. Repeat with the other charcoal lter. Then replace the grease lters
and cover panels.
To attach a new charcoal lter, rst remove the grease lters as described
above. Then oer up the charcoal lter to the side of the motor as shown in
gure 3 and turn it clockwise until it locks into place. Repeat with the other
charcoal lter on the other side of the motor. Then replace the grease lters
and cover panels.