Specifications

4
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING
OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE
ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif)
will scratch the surface and could erase the control panel markings.
You can clean your extractor eectively by simply using a dilute solution of
water and mild detergent and drying to a shine with a clean cloth.
Cleaning the grease lter
The grease lters should be kept clean to minimise the risk of re.
When the display ashes alternating the speed selected with the letter A,
or at least once a month, you should remove and clean the grease lters
with hot soapy water. You can also wash the grease lters in a dishwasher,
ensuring that you place it in an upright position to prevent damage from
other items in the dishwasher. After rinsing and drying, replace the lters.
After the grease lters has been replaced, the electronic memory must be
reset by touching key A for approximately ve seconds, until the letter A
stops ashing.
To remove the grease lters follow the steps below:
1. Pull open the handle on the grease lter as shown in g 2. It will release
at the handle side.
2. Then lower the grease lter to remove it completely.
To replace the grease lters, repeat the steps in reverse.
Please note:
Cleaning the grease lter in the dishwasher may lead to discolouration. This
is normal and does not constitute a fault with the appliance.
Fig. 2