Specifications

Installation

Mounting the extractor to the ceiling:

1. Using the supplied template, drill four holes in the ceiling and t suitable

wall plugs into the holes, if required. Note that plugs may not be required

if the extractor is to be mounted directly to the ceiling joists. Ensure that

the wall plugs used are suitable for the intended purpose. See g 15

2. Fit three screws into the holes (or direct to the joists) leaving at least

3mm standing proud, as shown in g 16. Note that a screw should not be

tted in the hole marked X on the diagram.

3. Using the help of another individual, locate the extrac tor on the three

exposed ceiling screws and rotate into position. Tighten the three screws

and then secure the whole assembly in position using a screw in hole X.

The extractor should be free standing at this point. See g 17 below.

Fig. 15

Fig. 16

Fig. 17