Specifications

11
Installation
Assembling the extractor ready for mounting:
1. Place the extractor body on a table and x the support sections (D) using
the supplied screws (E) as shown in g 11 below.
2. Remove the screws(A) fastening the lower and upper(B) support sections
as shown in g 12 below.
3. Measure the height of the ceiling and then the hotplate height from the
oor. The height of the hob assembly, including the body should be
equal to:
Ceiling height – (H + Hotplate height)
Where H= 600mm minimum for electric hobs and 700mm minimum for
gas hobs
Note that if the extact height cannot be set, use the support position
corresponding to the next highest one to prevent any issues with installation
heights above hobs.
Fig. 11
Fig. 12