manual
3
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE
EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will
scratch the surface and could erase the control panel markings.
You can clean your extractor eectively by simply using a dilute solution of water
and mild detergent and drying to a shine with a clean cloth.
Cleaning the grease lter
The grease lters should be kept clean to minimise the risk of re.
When the display ashes alternating the speed selected with the letter A, or at
least once a month, you should remove and clean the grease lters with hot soapy
water. You can also wash the grease lters in a dishwasher, ensuring that you place
it in an upright position to prevent damage from other items in the dishwasher.
After rinsing and drying, replace the lters. After the grease lters has been
replaced, the electronic memory must be reset by touching key A for
approximately ve seconds, until the letter A stops ashing.
To remove the grease lters follow the steps below:
1. Pull open the handle on the grease lter as shown in g 2. It will release
at the handle side.
2. Then lower the grease lter to remove it completely.
To replace the grease lters, repeat the steps in reverse.
Please note:
Cleaning the grease lter in the dishwasher may lead to discolouration. This is
normal and does not constitute a fault with the appliance.
Changing the charcoal lter (re-circulating only)
When the display ashes alternating the speed selected with the letter F, the
charcoal lters must be replaced. After the charcoal lter has been replaced, the
electronic memory must be reset by touching key A for approximately ve
seconds, until the letter F stops ashing.
To attach a new charcoal lter, rst remove the grease lters as described above.
Then oer up the charcoal lter to body of the extractor as
shown in gure 3. Repeat with the
other charcoal lter. Then replace the grease lters.
Fig. 2
Fig. 3