manual
3
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE
EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will
scratch the surface and could erase the control panel markings.
You can clean your extractor eectively by simply using a dilute solution of water
and mild detergent and drying to a shine with a clean cloth.
Cleaning the grease lter
The grease lter should be kept clean to minimise the risk of re.
When the display ashes alternating the speed selected with the letter A, or at
least once a month you should remove and clean the grease lter with hot soapy
water. You can also wash the grease lter in a dishwasher, ensuring that you place
it in an upright position to prevent damage from other items in the dishwasher.
After rinsing and drying, replace the lter. After the grease lter has been replaced,
the electronic memory must be reset by touching key A for approximately ve
seconds, until the letter A stops ashing.
To remove the grease lter follow the steps below:
1. Open the glass cover panel as shown in g 2.
2. Pull open the handle on the grease lter as shown in g. 2. It will release
at the handle side. Then lower the grease lter to remove it completely.
To replace the grease lter, repeat the steps in reverse.
Please note:
Cleaning the grease lter in the dishwasher may lead to discolouration. This is
normal and does not constitute a fault with the appliance.
Changing the charcoal lter (re-circulating only)
When the display ashes alternating the speed selected with the letter F, the
charcoal lters must be replaced. After the charcoal lter has been replaced,
the electronic memory must be reset by touching key A for approximately ve
seconds, until the letter F stops ashing.
To attach a new charcoal lter, rst open the body of the extractor as shown in
gure 3. Then oer up the charcoal lter into the frame as shown in gure 4 until
it locks into place. Repeat with the other charcoal lter, then close the body of the
extractor..
Fig. 3
Fig. 4
Fig. 2
1
2
1
2
2