manual
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE
EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will
scratch the surface and could erase the control panel markings.
You can clean your extractor eectively by simply using a dilute solution of water
and mild detergent and drying to a shine with a clean cloth.
Cleaning the grease lter
The grease lter should be kept clean to minimise the risk of re.
When the display ashes alternating the speed selected with the letter A, or
at least once a month you should remove and clean the grease lter with hot
soapy water. You can also wash the grease lter in a dishwasher, ensuring that
you place it in an upright position to prevent damage from other items in the
dishwasher. After rinsing and drying, replace the lter. After the grease lter
has been replaced, the electronic memory must be reset by touching key A for
approximately ve seconds, until the letter A stops ashing.
To remove the grease lter follow the steps below:
1. Remove the stainless steel cover panels as shown in g 2.
2. Pull open the handle on the grease lter as shown in g. 3. It will release at
the handle side. Then lower the grease lter to remove it completely.
To replace the grease lter, repeat the steps in reverse.
Please note:
Cleaning the grease lter in the dishwasher may lead to discolouration. This is
normal and does not constitute a fault with the appliance.
Changing the charcoal lter (re-circulating only)
When the display ashes alternating the speed selected with the letter F, the
charcoal lters must be replaced. After the charcoal lter has been replaced,
the electronic memory must be reset by touching key A for approximately ve
seconds, until the letter F stops ashing.
To attach a new charcoal lter, rst remove the cover panels and lters as
described above. Then oer up the charcoal lter to the side of the motor as
shown in gure 4 and turn it clockwise until it locks into place. Repeat with the
other charcoal lter on the other side of the motor. Then replace the grease lters
and cover panels.
3
Fig. 2
Fig. 3
Fig. 4
1
2